Has taken the armor plate carrier to the next level. Convertible dual pocket design which can accommodate either a 8″x 10″ or 10″ x 12″ single plate. Our lightweight quick donning carrier vest complete with 10″ x 12″ or 8″ x 10″ AR500 Level III plate. Fits sizes from Medium through XXlarge. Weighing in at only 1.5 pounds empty is our most lightweight carrier. Tactical Scorpion Gear Lightweight carrier vest. This vest provides pockets for the front and rear armor up to 10? X 12? . Made of 600D nylon. This vest comes complete with armor. This is a Tactical Scorpion Gear exclusive design. Plate weights: 10×12: 135 ounces 8×10: 91 Ounces. Made for quick and easy placement for in case of emergency. Armor type: Complete with 2 AR500 steel Level III plates in the size of your choice. Size: Fully adjustable shoulder straps and girth. Small to XXLarge. Dual pocket design with Velcro. Quick donning / doffing with no clips or fasteners to fuss with. Tactical Scorpion Gear AR500 steel plate armor. (Made in the USA). A stand alone armor plate with multiple hit capability. Fully encapsulated to protect against corrosion, chemicals and sweat. Full spall build-up coating available for additional charge. Fully tested by independent Lab. Rated for up to six hits from 7.62 Nato bullets. 308 Winchester with velocities up to 2780 fps. For front and/or back protection. 10 x 12 plate weighs 8 pounds each. We utilize a CNC laser cutting table for the cutting of all our AR500 products. Plasma cutting cuts slowly, this puts a lot of heat into the steel. (Submerged plasma cutting machine is no better) This excess heat can result in excessive chipping and damage near the cut edge during use and easily shattering when shot. Plasma cutting generates large amounts of heat that is deposited into the target, softening it’s edges. The heat-affected zone (HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel. Most AR500 is cut with plasma cutters as they are cheap and relatively small compared to other methods. Our Curved plate is bent on a custom laser cut die set with single radius bend, not bent multiple times on a press brake. Here at Tactical Scorpion Gear we manufacture our own vest carriers, aramid level IIIA vests and all our products. This model complies with NIJ Standard-0101.06 for Ballistic Resistance of Body Armor. NIJ tested Level III Armor will defeat 6 rifles round shots up to 7.62×51/. By purchasing the body armor contained in this listing from East West Consolidated, LLC, d/b/a Tactical Scorpion Gear. Agree to be bound by the following terms and conditions. Purchaser represents that s/he is at least 18 years old or the age of majority in the State or Territory in which s/he resides. Purchaser is encouraged to seek qualified legal counsel in his/her jurisdiction if Purchaser has any questions concerning ab federal, state, or local laws. S violation of any federal, state, or local law concerning the Purchaser. S body armor is tested to withstand bullets, the armor is bullet resistant and not bulletproof. Body armor will not protect someone from injury or death in all circumstances. Body armor will not provide any protection for the parts not covered by the armor. Purchaser acknowledges that there is always a risk of injury, including serious injury or death, if struck by a bullet while wearing body armor. ALL WARRANTIES, INCLUDING THE WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY, ARE HEREBY EXCLUDED. These Terms and Conditions may be updated, revised, or changed without prior notice.